53 minutes ago, -Daedalus said:

Since there's lots of room

Depends on the minimum screen resolution considered for the UI.

 

If it's a small/old VGA monitor attached directly to the server for occasional maintenance, there might not be as much space as shown above.

On 4/23/2022 at 11:36 AM, SimonF said:

This has now been added and should be in RC5. Below is on an internal test release and loopbacks are not shown now.

 

 

mmh i dont see that column "capacity" in RC7 vm overview.
would love to see the IP adresses of the vms there like on that screenshot..

Edited May 25, 20224 yr by Stri

5 minutes ago, Stri said:

 

mmh i dont see that column "capacity" in RC7 vm overview.
would love to see the IP adresses of the vms there like on that screenshot..

You neex to click on the vm name for it to show and have the guest agent installed on the vm.

 

Can you provide a screenshot

13 hours ago, SimonF said:

You neex to click on the vm name for it to show and have the guest agent installed on the vm.

 

Can you provide a screenshot

 

Guest Agent was not installed.
Now it's working, thanks!

 

BTW - it would be even nicer to see the IP without clicking on the VM, maybe configureable as a fixed column?

 

Edit: OK with all that different network interfaces it would not look that nice maybe...

Edited May 26, 20224 yr by Stri

The general unraid console log tells you the dhcp address of any just started VM. This should be very easy to add to the UI.

Edited September 30, 20223 yr by dopeytree

19 minutes ago, dopeytree said:

The general unraid console log tells you the dhcp address of any just started VM. This should be very easy to add to the UI.

The unraid log doesnt not show guest dhcp addresses. That is an internal address.

 

you need to use guest agent to get guest IPs. Which is already there if you click on the vm name.