Jump to content
darkcyde

Network Bonding Assistance

2 posts in this topic Last Reply

Recommended Posts

Hi

I currently have two NICs, one is a 4 port assigned completely to a VM for pfSense, and the other is an on-board 2 port for UnRaid.

 

They are currently configured as two separate ports with a unique IP, but I would like to bond them together to spread the bandwidth across both ports, but I can't seem to configure it....at some point I seem to have created two Bond groups and now each port is assigned to a Bond group of its own and I can't change this....can anyone help?

 

I've attached a screenshot of my network config page below...

 

 screenshot.bonding.thumb.jpg.fc725616e916017544e3609be83535d6.jpg

Share this post


Link to post

Remove bonding from eth1.

Then add eth1 as bond member of eth0.

 

Share this post


Link to post

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now