torch2k Posted February 1, 2020 Share Posted February 1, 2020 (edited) My motherboard currently has eth0 and eth1 set as a br0 bond. I've added a new 10Gb NIC that is showing up as eth2 and eth3. I believe I can edit my Dockers and tell them to use the new br3 bond, but what about my SMB shares? I would like to connect to my shares over the local network using the new 10Gb NIC, not sure how to tell Unraid to use that connect over the motherboard's. network-rules.cfg network.cfg Edited February 1, 2020 by torch2k Quote Link to comment
bonienl Posted February 1, 2020 Share Posted February 1, 2020 You need to change the "Interface Rules" and set one of your 10G interfaces as eth0. A reboot is required afterwards, make sure your new 10G interface is properly connected. 1 Quote Link to comment
torch2k Posted February 1, 2020 Author Share Posted February 1, 2020 That worked, thanks! Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.