John S

SOLVED.....I was able to get the docker app to work by disabling the docker, deleting the docker image and reinstall the docker apps.

I'm still learning unraid and just about 2 months ago I used CA backup app with the intent of backing up my primary server info but instead ending up ERASING every bit of media and personal files from my server. It has taken just at 2 months to NEARLY finish my rebuild but 2 days ago I ran into another issue. Despite having an ups backup a power outage while I was not home shutdown the server. Once it booted back up the parity check ran and found and corrected thousands of errors. The problem is that I can't access any of the container apps remote or locally now. I can boot up the server, log into it, and my container apps all show as running (Plex, NZB, Radar, Sonar, etc) but when I try to access them through the webui I get an error. When trying to access Plex from any outside application it says server is unavailable.

Just updated to the new 6.11.1 and seems to be working fine now.. Thanks!

So just to make sure that I didn't miss anything, I just repeated the entire process with the same results. I upgraded to 6.11.0 from within the menu. After rebooting the system went into a repeating loop. I copied all 11 bz files + change.txt file from a downloaded copy of 6.11.0, no change. I copied and replaced all bz files & the change.txt from the previous folder. Rebooted and it worked.

That's what we did do. I copied all of the bz files expect the image file, when that didn't work then I copied the bz image as well, no change. Now I did not copy the txt file. I'll go back and try to update it again and if it get stuck again at least I'll have a road map back to getting it working again.

So it's back up and working but not fixed. I found the download page and downloaded 6.11.0. I copied all of the bz files except for the bzimage and rebooted it. It went one step further from previously. The bzimage ok (previously shown) and now showed bzroot ok (not previously shown) but it rebooted again from that point. Since I'm not sure what bz files are or what they do I then looked into the previous file folder on the unraid thumb drive and copied all of those bz files and the system rebooted. It apparently reverted back to 6.10.3 but it is working. Couldn't get 6.11 to work so I guess I'll wait on the next update. Thank you for the assist!

Where can you do that? I'm not seeing a downloadable link or section on the website.

This is an i9-9900k system running with 32gb of memory. Primarily used for Plex. This is about my 6 or 7th plex server but my 1st Unraid. I buillt this one to run on Unraid which it has been since day 1 which is approx 2 years ago.

After the menu comes up then below that it says "loading bzimage Ok" then says "loading bzroot" and reboots.

I just installed 2 new 14tb Exos Drives and they show up unassigned device but I can't format them. It comes up Fail. I then took them out formatted them to exact and reinstalled. Both drives still shows up but fails every time I try to format.

It worked today!!!! No different than last night but hey it's working. To answer your question however, no proxy, no vpn, ip similar to my Mac (server sitting next to me). Regular lan network with cable company router/modem (xfinity).

ok I've now changed to one of the servers listed and it Delugevpn still won't open (WebUI). Attached is the latest log. supervisord1.txt

supervisord copy.txt Attached is the log file. Thanks for the help