painted-champagne6111

Just wanted to add that for Z390 Aorus Wifi, installing the IT87 driver (without force_id or lax) and setting the system fans to auto for control mode and system1 as temperature monitor (not sure if the 2nd is necessary) the autofan control seems to be able to at least detect min PWN correctly with fan actually stops during detection. Will report back on actual control.

Make sense! Will do!! Thx so much!

I don't recall testing w/ the script. Definitely will look into it! Thanks so much!!

Thanks for your replies!! I actually ran the extended SMART tests twice before the preclear. Both times failed w/ 10% remaining w/ read errors. Based on your replies I think the drives are their way out. Just a bit over three years... data never exceeded 2 TB in total, probably every day there was a write about less than 1 GB to the drive from laptop document backup. Do you think if I used it wrong or is 3 years pretty typical for ironwolf? Thanks a lot!

Please see pre-clear report below. Ironwolf 4 TB, ~ 3 years. I was using them with a NAS box then recently built a DIY one w/ HP Elitedesk from 2020 I think. Previous NAS never reported any errors. The new setup has been running for ~ 1 month. All a sudden unRAID starts showing read errors. I looked on the forum and decided to do a pre-clear and see how it goes. Preclear "successful" but Reallocated_Sector_Ct and Reported_Uncorrect increased w/ preclear. Is this likely a disk or MB issue? If disk, can the disk still be used given preclear successful or is it RIP/RMA? Thanks so much for your input!! #################################################################################################### # Unraid Server Preclear of disk ________ # # Cycle 1 of 1, partition start on sector 64. # # # # Step 1 of 5 - Pre-read verification: [7:19:14 @ 151 MB/s] SUCCESS # # Step 2 of 5 - Zeroing the disk: [7:18:00 @ 152 MB/s] SUCCESS # # Step 3 of 5 - Writing Unraid's Preclear signature: SUCCESS # # Step 4 of 5 - Verifying Unraid's Preclear signature: SUCCESS # # Step 5 of 5 - Post-Read verification: [7:09:23 @ 155 MB/s] SUCCESS # # # # # # # #################################################################################################### # Cycle elapsed time: 21:46:42 | Total elapsed time: 21:46:43 # #################################################################################################### #################################################################################################### # S.M.A.R.T. Status (device type: default) # # # # ATTRIBUTE INITIAL CYCLE 1 STATUS # # Reallocated_Sector_Ct 72 104 Up 32 # # Power_On_Hours 29731 29753 Up 22 # # End-to-End_Error 0 0 - # # Reported_Uncorrect 386 561 Up 175 # # Airflow_Temperature_Cel 34 38 Up 4 # # Current_Pending_Sector 24 0 Down 24 # # Offline_Uncorrectable 24 0 Down 24 # # UDMA_CRC_Error_Count 0 0 - # # # #################################################################################################### # # #################################################################################################### --> ATTENTION: Please take a look into the SMART report above for drive health issues. --> RESULT: Preclear Finished Successfully!.

Thx!! how did you get it to work? I couldn't wake up any VM from any state... Thanks so much!

also having troubles to get WoL to work for VM w/ unraid 6.12.4. Anyone still able to make it work? Thanks so much!