very high raw read rate error common in reconstruction?

[icedragonslair]

Is a very high raw read rate error common in reconstruction? I haven't been here after a failure so any help would be awesome.

 

thank loads,

 

Ice

 

mediaserver1-syslog-20210212-2004.zip

Edited February 12, 2021 by icedragonslair

[Squid]

You should post your complete diagnostics.zip file, not just the syslog

 

BUT, presumably from having to tear through the syslog your screenshot is from the parity drive, in which case that particular attribute is normal on a Seagate drive since it reports it differently than your data drives (WD)

[icedragonslair]

2 hours ago, Squid said:

You should post your complete diagnostics.zip file, not just the syslog

 

BUT, presumably from having to tear through the syslog your screenshot is from the parity drive, in which case that particular attribute is normal on a Seagate drive since it reports it differently than your data drives (WD)

Thanks Squid, sorry i sent the wrong one, here it is

 

And thanks again,

Ice

mediaserver1-diagnostics-20210212-2200.zip

[Squid]

Seagates report Raw Error Rate differently than WD, and a non zero (and very high) number in there is quite normal.

[icedragonslair]

Thank you for confirming that squid, and thanks for all your help

 

Ice