glennbrown Posted September 20, 2021 Share Posted September 20, 2021 So a little back story, moving from a setup where I was using Ubuntu with Snapraid/MergerFS. I cleared off one of my 12TB data drives and setup the Unraid Array with my old snapraid 12TB Parity Drive and the other 12TB Data drive. Then used Unassigned devices and Krusader to start moving data over from my two 10TB drives. I finished up the first 10TB drive and am ready to bring that drive into the array. However it is giving me a error about not being able to add/remove disks. I had saw a few threads that before you can add more drives you need to let a partiy check finish. I had it paused while I was migrating data. Can someone confirm that is the case? Quote Link to comment
itimpi Posted September 20, 2021 Share Posted September 20, 2021 8 minutes ago, glennbrown said: So a little back story, moving from a setup where I was using Ubuntu with Snapraid/MergerFS. I cleared off one of my 12TB data drives and setup the Unraid Array with my old snapraid 12TB Parity Drive and the other 12TB Data drive. Then used Unassigned devices and Krusader to start moving data over from my two 10TB drives. I finished up the first 10TB drive and am ready to bring that drive into the array. However it is giving me a error about not being able to add/remove disks. I had saw a few threads that before you can add more drives you need to let a partiy check finish. I had it paused while I was migrating data. Can someone confirm that is the case? Not tested that exact case but it is almost certainly true as you cannot have 2 full array level operations running at the same time and parity check and adding disks both fall into that category. note that while migrating data if you want to maximise speed you should run with no parity drive at all, and then add it afterwards. This does, however, mean you are not protected until you have added the parity drive and finished building parity. Quote Link to comment
JorgeB Posted September 20, 2021 Share Posted September 20, 2021 14 minutes ago, glennbrown said: I had saw a few threads that before you can add more drives you need to let a partiy check finish. You need to let a parity sync finish, parity check you can just cancel and add the drives. Quote Link to comment
glennbrown Posted September 20, 2021 Author Share Posted September 20, 2021 25 minutes ago, JorgeB said: You need to let a parity sync finish, parity check you can just cancel and add the drives. Ok double checked it is in fact a parity-sync/data rebuild. Don't suppose I can stop it and the remove the parity drive for now so I can continue data migration. Quote Link to comment
JorgeB Posted September 20, 2021 Share Posted September 20, 2021 18 minutes ago, glennbrown said: Don't suppose I can stop it and the remove the parity drive for now so I can continue data migration. You can. Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.