HDGuy Posted February 14, 2022 Share Posted February 14, 2022 (edited) New setup, just trying to get everything working properly. I have a FIOS gigabit connection, and installed both Sabnzbd and NZBGet dockers and both seem to be limited to 60MB/s. Downloads on my PC typically max out at ~110MB/s. I'm downloading to a SSD/NVME on both systems so that's not the issue. I must have something else going on. With the speedtest docker it reports I'm maxing out the connection to my Unraid box with ~950/980 so that's not it either. I realize it's an older setup (Xeon e3-1226-v3) but AFAIK that shouldn't keep my download speeds from maxing out. Any ideas would be really helpful. I plan to buy a license as soon as I make sure everything's working OK. Edit- I think I have my folders setup improperly and I'm writing to the array, not to cache? monster-diagnostics-20220214-1540.zip Edited February 14, 2022 by HDGuy Quote Link to comment
Squid Posted February 14, 2022 Share Posted February 14, 2022 How many connections are you allowing on NZBGet? You should pretty much use as many as your provider allows (eg: 20) What is presumably your downloads (d.......s) share is set to use cache: yes, so new files get written to the cache drive and ultimately moved to the array You appdata is spanning between disk 1 and the cache. You should stop docker in Settings - Docker, run mover then re-enable it after the move is done. Quote Link to comment
HDGuy Posted February 15, 2022 Author Share Posted February 15, 2022 (edited) 30 minutes ago, Squid said: How many connections are you allowing on NZBGet? You should pretty much use as many as your provider allows (eg: 20) What is presumably your downloads (d.......s) share is set to use cache: yes, so new files get written to the cache drive and ultimately moved to the array You appdata is spanning between disk 1 and the cache. You should stop docker in Settings - Docker, run mover then re-enable it after the move is done. Maxing out connections on both SAB and NZBGet- I'm using 2 newsservers on different backbones with 50 connections each . On my Gigabit connection it can handle it- I tried using less but I maximize transfer speed by using all of them. It seems like my setup does slightly better with SAB. I just benchmarked all my drives using the DiskSpeed docker- my motherboard is using the old C226 chipset so I have to use a PCIe NVME controller but I'm getting 2500MB/s writes so there is definitely something else going on. I must have configured it wrong. Learning process. Edited February 15, 2022 by HDGuy Quote Link to comment
MrChunky Posted January 19, 2023 Share Posted January 19, 2023 Did you come to some conclusion with this? I am having a similar issue... Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.