danimal86 Posted February 15, 2022 Share Posted February 15, 2022 I just upgraded my dual parity drives from 2 14tb to 2 16tb drives. Went smoothly, just swaped a parity drive and rebuilt parity for each drive change. So i had 2 14tb drives just sitting there and no extra sata power connectors, so i used unbalance to move all the data off of a 2tb drive (trying to consolidate all data to 4 14tb drives instead of the hodge podge of 2/3tb'ers. I was following the spaceinvaders video (not realizing there was a way to do it without the parity rebuild, later in his video) and powered down and removed the 2tb drive and installed the 14tb drive. Fired up the array and did a New Config and made sure the correct 16tb drives were in the correct parity slots...and started the parity rebuild (about half way through as of right now). It says the 14tb i installed is Unmountable: No File System. I figured it would do that since is used to be a parity drive and now is a data drive. I see the format option at the bottom below Stop the Array. Is it safe to do this while a parity rebuild is happening? i was just hoping to save some time since i'm sure formatting will take a bit for 14tb. Quote Link to comment
Solution JorgeB Posted February 15, 2022 Solution Share Posted February 15, 2022 18 minutes ago, danimal86 said: Is it safe to do this while a parity rebuild is happening? Yes. Quote Link to comment
danimal86 Posted February 15, 2022 Author Share Posted February 15, 2022 (edited) 13 minutes ago, JorgeB said: Yes. Thanks! I'll start the format! Once its done with the format, it'll show up in the array automagically? Edit: Looks like it pauses the parity rebuild: Array Started • Formatting device(s) • Parity-Sync / Data-Rebuild 58.4 %(Paused) Edit2: Nevermind...parity rebuild is back up and running a second after i posted the Paused rebuild Edited February 15, 2022 by danimal86 Quote Link to comment
JorgeB Posted February 15, 2022 Share Posted February 15, 2022 Yes, it pauses for a few seconds (couple minutes max) or the format would take a long time, and disk will be available after the format is done. Quote Link to comment
danimal86 Posted February 15, 2022 Author Share Posted February 15, 2022 1 minute ago, JorgeB said: Yes, it pauses for a few seconds (couple minutes max) or the format would take a long time, and disk will be available after the format is done. Thanks! It looks like the rebuild counter restarted, but current position shows the rebuild is still going strong: Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.