heoquoay Posted February 28, 2023 Share Posted February 28, 2023 I have a supermicro server, and I added a new 10gbe NIC card to upgrade the speed. Do I need to configure anything in the bios or it usually work right away? Cause mine doesn't connect. Quote Link to comment
JorgeB Posted February 28, 2023 Share Posted February 28, 2023 Please post the diagnostics. Quote Link to comment
heoquoay Posted February 28, 2023 Author Share Posted February 28, 2023 7 hours ago, JorgeB said: Please post the diagnostics. Just got home. Here is the diagnostics diagnostics-20230228-1836.zip Quote Link to comment
JorgeB Posted March 1, 2023 Share Posted March 1, 2023 Both 10GbE NICs are being detected and the driver installed but no link is being detected on either one: Link detected: no Quote Link to comment
heoquoay Posted March 1, 2023 Author Share Posted March 1, 2023 3 hours ago, JorgeB said: Both 10GbE NICs are being detected and the driver installed but no link is being detected on either one: Link detected: no Yeah I put the ethenet back to the main old port because it doesn't run when I use the new one. I'll check the bios tonight. Quote Link to comment
heoquoay Posted March 2, 2023 Author Share Posted March 2, 2023 (edited) I kinda figure it out from Interface eth0. but my new network speed is still the same as my old one 1000 Mbps, full duplex, mtu 1500. The wire is flat cat 7 connect direct to the router Edited March 2, 2023 by heoquoay Quote Link to comment
JorgeB Posted March 2, 2023 Share Posted March 2, 2023 Make sure there's no bond with the gigabit NIC. Quote Link to comment
heoquoay Posted March 2, 2023 Author Share Posted March 2, 2023 5 hours ago, JorgeB said: Make sure there's no bond with the gigabit NIC. Is that in unraid setting? Where do I check for that? Quote Link to comment
JorgeB Posted March 2, 2023 Share Posted March 2, 2023 Settings -> Network Settings Quote Link to comment
heoquoay Posted March 3, 2023 Author Share Posted March 3, 2023 10 hours ago, JorgeB said: Settings -> It still 1000 mbps after turn off bonding Quote Link to comment
caplam Posted March 3, 2023 Share Posted March 3, 2023 (edited) i also added a 10Gb sfp+ card yesterday in my server. At first boot card was detected but no link. At second reboot i was able to modifiy it to be eth0 and link was established. There was just bridging and no bonding Edited March 3, 2023 by caplam Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.