Njon Posted February 13, 2014 Share Posted February 13, 2014 Hi all, I'm really starting hating this motherboard. Since the day I bought it I have had always the same problem: IPMI picks up wrong temperatures or wrong fan speed. This means that every now and then fans spin at maximum RPM and the buzzer start beeping loudly. I updated the firmware and also the BIOS but the problem persist! My log is full of "Lower Non-Critical - Going Low - Asserted", sometime referred to the CPU fan, sometime to the SYS fan. I really don't know what is happening. Any suggestion? Link to comment
Njon Posted February 16, 2014 Author Share Posted February 16, 2014 Nobody? Sent from my iPhone using Tapatalk Link to comment
Ford Prefect Posted February 16, 2014 Share Posted February 16, 2014 ...all I can suspect is, that this might be linked with what you are experiencing with your board: http://lime-technology.com/forum/index.php?topic=31376.msg284931#msg284931 Link to comment
Njon Posted April 10, 2014 Author Share Posted April 10, 2014 I found what causes the motherboard to beep: sometimes the system senses that the CPU fan is at 0 rpm even if the fan is not connected! Updating the bios desn't seem to solve the problem Sent from my iPhone using Tapatalk Link to comment
garycase Posted April 11, 2014 Share Posted April 11, 2014 I found what causes the motherboard to beep: sometimes the system senses that the CPU fan is at 0 rpm even if the fan is not connected! Updating the bios desn't seem to solve the problem Sent from my iPhone using Tapatalk ?? There isn't a CPU fan on this board -- it's passively cooled !! Link to comment
c3 Posted April 11, 2014 Share Posted April 11, 2014 There are in fact two fan connectors on the x7spa and if 0 rpm is detected an assertion can be generated. Can you generate the output for "ipmitool sensor"? Link to comment
garycase Posted April 11, 2014 Share Posted April 11, 2014 ... There are in fact two fan connectors on the x7spa ... True. And if they're enabled they will indeed generate warnings if the fans aren't spinning. HOWEVER ... according to the manual, "... The default setting is Disabled." ==> which, of course, makes sense, as the CPU uses passive cooling. I suppose the BIOS may have been inadvertently modified to enable this warning -- in which case the solution is to simply disable it Link to comment
Njon Posted April 13, 2014 Author Share Posted April 13, 2014 There are in fact two fan connectors on the x7spa and if 0 rpm is detected an assertion can be generated. Can you generate the output for "ipmitool sensor"? I don't have the ipmitool package... And in the bios I have no option regarding cpu fan... Help... Link to comment
Njon Posted April 24, 2014 Author Share Posted April 24, 2014 Nobody? It's becoming really annoying Sent from my iPhone using Tapatalk Link to comment
Recommended Posts
Archived
This topic is now archived and is closed to further replies.