Johnny Posted August 3, 2016 Share Posted August 3, 2016 Upgrading from 4.7 to 6 and I'm a nervous nelly right now. I'm going down the wiki instructions, I have unraid running, can see the new GUI, I have assigned my parity and data drives, and the array is still stopped. Do I start the Array, THEN do the new permissions tool, or do the permissions tool now before starting the array. Link to comment
Squid Posted August 3, 2016 Share Posted August 3, 2016 Upgrading from 4.7 to 6 and I'm a nervous nelly right now. I'm going down the wiki instructions, I have unraid running, can see the new GUI, I have assigned my parity and data drives, and the array is still stopped. Do I start the Array, THEN do the new permissions tool, or do the permissions tool now before starting the array. It has to be run with the array started. Link to comment
Johnny Posted August 3, 2016 Author Share Posted August 3, 2016 It started a parity sync which was expected but can I stop it and do the permissions tool now and sync later? Link to comment
Squid Posted August 3, 2016 Share Posted August 3, 2016 It started a parity sync which was expected but can I stop it and do the permissions tool now and sync later? The order you do it in doesn't matter. Link to comment
itimpi Posted August 3, 2016 Share Posted August 3, 2016 Technically you could run the New Permissions tool while a parity sync is in progress. The parity sync will be slowed by interactions between the two processes but should both run OK. Having said that running them seperately is still a good idea. Link to comment
Johnny Posted August 4, 2016 Author Share Posted August 4, 2016 It's all up and running and my blood pressure is back to normal I'm all out of free SATA connections on my board now, but I'll post in hardware on recommendations after searching thanks guys. Link to comment
Recommended Posts
Archived
This topic is now archived and is closed to further replies.