LordGrande Posted August 11, 2020 Share Posted August 11, 2020 Hi, I was trying to boot a usb for install UNRAID, i was using the tool UNRAID USB Creator and i found a method for do it manualy... BUT in the 2 scenarios the issue is the same: Black Screen.... 2 minute later 2 "bips" from the motherboard but no output... I trying booting in legacy mode and uefi mode My system is: Motherboard: Supermicro X10DRi (Last bios installed) Processor: 2x e5 2860 v3 RAM: 64 GB DDR4 ecc 3 SSD: 1x 500gb and 2x 120gb Now i have proxmox installed but i want to install only UNRAID Thank you! Quote Link to comment
trurl Posted August 11, 2020 Share Posted August 11, 2020 22 minutes ago, LordGrande said: found a method for do it manualy Do you have a link? Quote Link to comment
LordGrande Posted August 11, 2020 Author Share Posted August 11, 2020 8 minutes ago, trurl said: Do you have a link? Yes, https://wiki.unraid.net/UnRAID_6/Getting_Started Section: "Manual Method (Legacy)" Quote Link to comment
ChatNoir Posted August 11, 2020 Share Posted August 11, 2020 Are your BIOS and unRAID key on the same page as for UEFI/Legacy ? My MB is from the same generation from Supermicro I think and works well in UEFI. I forced this in the BIOS and the USB creator. (it might work well also in legacy mode, I didn't try). Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.