Ellissss

have you read the instruction ? you need to add that line in boot device > and click flash then you need add the line i marked then you can continue follow MisterMue instruction by add GPU stats, jellyfin container and service setup

hey, late to reply but i found the way to enable transcode by following MisterMue Guide i just add these line onto my flash drive it actually work on bbeirge-jellyfin and binhex jellyfin but Render/3D didn't show any statics like everyone show anything. however, if it work then it's working

igpu and gpu static able to known igpu, but should be show anything after started array ? intel gpu top report same and i tried to point /dev/dri at container but didn't work

i have same problem too and tried with so many ways to enable transcode by modified monprobe in config but none of them are work

i tried to follow but it didn't work, and intel_gpu_top didn't show anything running on igpu. any idea to fix this ?

any idea where i should run powertop command ? i follow Op thread from this post, but can't run it

alright, probably my psu prevent me to enter less 10 watt idle. i remember already enable Enhanced Halt State(C1E) on second test where i get 12 watt idle without ssd. for psu, i looking alternative at SFX size because i already had Jonsbo n2. however after trying more, your advice completely is work on my side (if not psu prevent me to have 10 watts idle ). thanks mate

this is suppose to be same program mention https://github.com/amitxv/SCEWIN/ ? i tried to follow everything and my motherboard keep prevent me going lower than 14 watts or 17.5 watt with display output My setup : i3-12100 Asrock B660m-itx/ac Team Elite Plus DDR4 32GB Corsair SF450 Crucial P3 Plus (Windows boot) SanDisk Cruzer Blade 16GB USB (Ubuntu Boot) APC BVX700LUI-MS first time i flash this motherboard everything was right without any problem. however at output said "nothing change" at .\SCEWIN_64.exe /i /lang 'en-US' /ms "LED MCU" /qv 0x0 /hb then i tried flash again but it said unknown command next, i enable most of ASPM option in bios then, boot to usb ubuntu to run powertop. it didn't show c state of my motherboard, however when i check on power usage suppose to be in C3 with 17.5 watt. device stats show my keyboard has "bad' stats so i remove during test, i tried unplug display and has 14 watt idle i did try to flash again, but it didn't work again. does i use correct app to do flash my motherboard ? i see everyone can get below 10 watt idle than me stuck at 17 watts edit : after changing PCIE ASPM Support to L0s, i able to hit c8 and c10 state but power usage at 14-15 watts with display output (c8 idle) and 12 watts without display (c10) i put back crucial p3 plus, and run powertop again at same settings, my pkg stucks at C3 around 15watt with display and 14watts without display, i probably change this ssd to sata in future even though i able to hit c10 but usage on tuya app show 12 watt idle still bummers for me. do you have more suggestion to do with it ? i'm looking more suggestion to able hit c10 states with power usage less that 10 watts

Hello mate, i'm excited to install unraid once all my pc component ready to build too