28 minutes ago, wgstarks said:

There have been multiple reports of this issue with multiple dockers after the 7.2.5 release. In my case I just have to change any setting and revert the change and apply the same settings I started with. Some people have reported that they actually had a port set to 0000 and they had to change it to the correct setting.

Thanks. Resetting the docker seemed to have fixed it.

supervisord.logcommand run.txtI need some help getting my prowlarr docker to connect to my VPN (PIA). You can see by the files that I did put the environment variables there but there's nothing about it in the supervisord.log file. I'm very confused at what could be missing or going on. I followed the directions laid out here, put the config and cert in the openvpn folder (I had to manually make the folder), and added all the various variables.

8 hours ago, gamer3192 said:

supervisord.logcommand run.txtI need some help getting my prowlarr docker to connect to my VPN (PIA). You can see by the files that I did put the environment variables there but there's nothing about it in the supervisord.log file. I'm very confused at what could be missing or going on. I followed the directions laid out here, put the config and cert in the openvpn folder (I had to manually make the folder), and added all the various variables.

Prowlarr doesn't have a vpn component, that read me is for containers with the vpn suffix e.g. delugevpn, qbittorrentvpn, sabnzbdvpn etc

Typical use case is downloaders (e.g. delugevpn) have the vpn setup, and you use container networking to use that containers vpn connection.

Edited May 17May 17 by tjb_altf4

13 hours ago, gamer3192 said:

supervisord.logcommand run.txtI need some help getting my prowlarr docker to connect to my VPN (PIA). You can see by the files that I did put the environment variables there but there's nothing about it in the supervisord.log file. I'm very confused at what could be missing or going on. I followed the directions laid out here, put the config and cert in the openvpn folder (I had to manually make the folder), and added all the various variables.

You can connect Prowlarr through a VPN by using the following guide-

https://github.com/binhex/documentation/blob/master/docker/faq/vpn.md

Scroll down to Q24.

You will need a working VPN docker prior to this setup. I use binhex-privoxyVPN. You will also need a working Prowlarr docker configuration.