Toskache Posted October 5, 2021 Share Posted October 5, 2021 (edited) Hello, I have changed my unraid system from a tower case to a 19'' server case. Mainborad, disks and controller stayed the same. Power supply is different and the Chenbro RM23612 has a backplane. After the conversion everything seemed to run fine, but after a short time the system reported a lot of read errors and kicked one data disk and one of the two parity disks out of the array. Then I installed a new 8TB disk as a data disk replacement and started the resync process. After about 2-3% there were thousands of read errors on other disks and the sync process stopped. I can do what I want, I can't get the array reconstructed. I then mounted all the data disks individually and backed up the data to two drives (unassiged). This worked without any problems. Without error messages. What else I tried: 1. "xfs_repair" on all disks. 2. change the SFF-8087 to SFF-8087 cable 3. selected several "replacement disks" for the failed data disk 4. cursed God and the world 5. was happy about the unraid concept (saved data) I have attached the diagnostic files. Does anyone have any ideas? Br Georg nas.fritz.box-diagnostics-20211005-1532.zip Edited October 17, 2021 by Toskache Quote Link to comment
JorgeB Posted October 5, 2021 Share Posted October 5, 2021 If backplane and PSU are the only things that changed that's where you should begin, try with a different PSU first, if issues persist it's likely the backplane. Quote Link to comment
Toskache Posted October 6, 2021 Author Share Posted October 6, 2021 @JorgeB Yes. I now have a "flying" setup with an external power supply and I have the disks connected without the backplane. So far about 65% of the rebuild is done - without errors. Remaining problem causes: PSU Backplane (electronics) Backplane (mechanics (SATA connectors)) Incompatibility between backplane and LSI SAS2308 Does the community's wealth of experience here have a favorite? Quote Link to comment
ChatNoir Posted October 6, 2021 Share Posted October 6, 2021 How was the backplane powered ? Is there a difference with your current temporary setup ? For exemple, how many leads from the PSU, splitters, Molex vs SATA, ... Quote Link to comment
Toskache Posted October 6, 2021 Author Share Posted October 6, 2021 1 hour ago, ChatNoir said: How was the backplane powered ? Is there a difference with your current temporary setup ? For exemple, how many leads from the PSU, splitters, Molex vs SATA, ... In the current, temporary setup I do not use the backplane. In normal operation, the backplane is powered with 4 Molex connectors (direct from PSU, no splitter). Quote Link to comment
Toskache Posted October 17, 2021 Author Share Posted October 17, 2021 I switched to another case with a new backplane. Works now fine for a while. THX. 1 Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.