TheCDay Posted May 8, 2018 Share Posted May 8, 2018 My old UPS was not large enough for my server (and it was old as dirt) so I replaced it. The ups daemon is still coming up with the voltage from the old UPS. I dont really see a way to update it or rescan. I went though the manual but.... im not really sure what I need to do. Thanks everyone. Link to comment
pwm Posted May 8, 2018 Share Posted May 8, 2018 Your very first step should be to figure out what UPS you have. Link to comment
Frank1940 Posted May 8, 2018 Share Posted May 8, 2018 What are you seeing on the 'UPS Details' tab on the UPS Settings page. In the second column is the 'Model Number'. Are you seeing the right model number of your new UPS? Link to comment
TheCDay Posted May 8, 2018 Author Share Posted May 8, 2018 I am now. I shut down the daemon and started it back up and after the scan everything came up correctly. Thank you for the responses, looks like it was just a glitch in the matrix. Make sure you tell the experts your UPS model number, its impotant Link to comment
pwm Posted May 9, 2018 Share Posted May 9, 2018 3 hours ago, TheCDay said: I know what ups I have. Nothing in your post mentions what UPS you have or how you have connected it. That means no one on this forum will know if they are using the same UPS model. Link to comment
limetech Posted May 9, 2018 Share Posted May 9, 2018 15 hours ago, pwm said: That means no one on this forum will know if they are using the same UPS model. It was a typical APC model, case closed. Link to comment
Recommended Posts
Archived
This topic is now archived and is closed to further replies.