Hasodi Posted December 20, 2019 Share Posted December 20, 2019 (edited) Unraid 6.8.0 and Unraid 6.8.0 rc8 I am unable to turn off/on VM manager. I do not have any VM installed. I can stop the array and do it but not while the array is online. Could this be a permission issue? IOMMU? Working as intended? Edited December 20, 2019 by Hasodi Quote Link to comment
JorgeB Posted December 20, 2019 Share Posted December 20, 2019 Known issue, fixed for next release: 1 1 Quote Link to comment
Hasodi Posted December 20, 2019 Author Share Posted December 20, 2019 As usual, thank you for the update. Quote Link to comment
xairam Posted December 22, 2019 Share Posted December 22, 2019 So for me its the other way round. I dont know why it isnt enabled anymorfe but i cant start it?!? Quote Link to comment
trurl Posted December 22, 2019 Share Posted December 22, 2019 4 minutes ago, xairam said: So for me its the other way round. I dont know why it isnt enabled anymorfe but i cant start it?!? Go to Tools - Diagnostics and attach the complete diagnostics zip file to your NEXT post. Quote Link to comment
xairam Posted December 22, 2019 Share Posted December 22, 2019 ok tower-diagnostics-20191222-0121.zip Quote Link to comment
trurl Posted December 22, 2019 Share Posted December 22, 2019 That diagnostic only has syslog of a few minutes since reboot. I didn't notice anything in the syslog about your issue. Have you actually attempted to enable VM since that syslog began (rebooted)? I do notice a number of warnings from FCP though. Why do you have so many dockers without templates? Did you have a problem with flash at some point? You can't manage a docker in the webUI if it doesn't have a template. Quote Link to comment
xairam Posted December 22, 2019 Share Posted December 22, 2019 I just started my Homeserver to test some VMs now. I dont use it much. If you mean the Flash drive not that i know off. The dead docker services are failed containers didnt bother me to remove them. Try since 30 min to turn the service on, but it doesnt even save changed settings. Quote Link to comment
JorgeB Posted December 22, 2019 Share Posted December 22, 2019 9 hours ago, xairam said: So for me its the other way round. The issue happens both ways, the problem is with the apply button, stop the array first and it should work. Quote Link to comment
xairam Posted December 22, 2019 Share Posted December 22, 2019 29 minutes ago, johnnie.black said: The issue happens both ways, the problem is with the apply button, stop the array first and it should work. Worked thx. Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.