dubbly Posted March 8, 2020 Share Posted March 8, 2020 This morning I found that one drive in my cache pool had been kicked out of the cache and was now in unassigned devices. Additionally, the remaining cache drive in the pool only shows a size of 8GB and not 500GB. So I tried to stop the array and unraid got stuck on stopping for an hour. So, I forced it with an unclean shut down but it restarts with the array started (and the same cache issue). Tried too stop the array again and same issue happens. Unraid will not stop the array it just says “Stopping” but doesn’t stop. Is there a setting I can adjust so it doesn’t start with the array up? What should I do? please help! Quote Link to comment
bobobeastie Posted March 8, 2020 Share Posted March 8, 2020 Settings->Disk Settings-> Set "Enable auto start" to No. Quote Link to comment
dubbly Posted March 8, 2020 Author Share Posted March 8, 2020 I have made that change. The server is still stuck at “stopping” the array after two hours. Power down from the GUI doesn’t work. I tried “powerdown -r” From the command line and it said it was going to powerdown But did not. The GUI is still accessible. Any ideas do I just need to do an unclean shut down? Quote Link to comment
Vr2Io Posted March 8, 2020 Share Posted March 8, 2020 (edited) What is "df" at command prompt output ? Anyway try umount most disk manually first before hard poweroff. Edited March 8, 2020 by Benson Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.