Green Dragon Posted October 22, 2022 Share Posted October 22, 2022 I have multiple GPUs. i5 10400 and NVidia 1050 (see image) When setting up the Plex Container and adding the --device=/dev/dri should I use /dev/dri/card? to select the card I wish to use? If i leave /card? off will Plex just select card0? Thanks! Quote Link to comment
MeisterPilaf Posted December 28, 2022 Share Posted December 28, 2022 *PUSH* Same issue. I have 1 IGPU and 2 additional GPU's. Plex is not using the IGPU when the others are installed and not passthroughed to the VM's. Quote Link to comment
xaositek Posted December 31, 2022 Share Posted December 31, 2022 I just built out an Intel 13900K which also has an nVidia 1660 card on it. The graphics card is not used by any VMs; it would be nice to somehow load share / balance between the two cards. Unsure how OP got both the nVidia and i905 drivers to show up in /dev/dri, but here is my outputs. Quote Link to comment
SimonF Posted December 31, 2022 Share Posted December 31, 2022 6 minutes ago, xaositek said: I just built out an Intel 13900K which also has an nVidia 1660 card on it. The graphics card is not used by any VMs; it would be nice to somehow load share / balance between the two cards. Unsure how OP got both the nVidia and i905 drivers to show up in /dev/dri, but here is my outputs. Have you enabled the igpu in bios? Quote Link to comment
MeisterPilaf Posted December 31, 2022 Share Posted December 31, 2022 Did you install the required software from the „community apps“ store? You have to install nvidia drivers and also for intel. But this does not solve your problem completely as i have the same issue. Its not possible to use the intel igpu when installed more gpus… Gesendet von iPhone mit Tapatalk Quote Link to comment
xaositek Posted December 31, 2022 Share Posted December 31, 2022 1 hour ago, SimonF said: Have you enabled the igpu in bios? Thank you! Got that that fixed up! 1 Quote Link to comment
MeisterPilaf Posted December 31, 2022 Share Posted December 31, 2022 Please tell me if you get it working.Gesendet von iPhone mit Tapatalk Quote Link to comment
xaositek Posted December 31, 2022 Share Posted December 31, 2022 7 minutes ago, MeisterPilaf said: Please tell me if you get it working. Gesendet von iPhone mit Tapatalk So I kept all the nVidia configuration in place which I knew was working and then added the /dev/dri as a new device. Once I did that, the iGPU was the first targeted GPU to do the work. Unfortunately I'm a bit out of time to try and max out the iGPU and see if it'll roll over to the nVidia card. Accord to this page (https://forums.serverbuilds.net/t/guide-hardware-transcoding-the-jdm-way-quicksync-and-nvenc/1408/2) it should work like this - "Plex will use QuickSync first in case of both a iGPU and Nvidia GPU installed." Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.