Jump to content

Slow Parity Check


clevoir

Recommended Posts

I am currenting running a partity check and am concerned about the speed, a check is run monthly and have noticed that it is getting slower every month

 

This is the current speed:-

 

Total size: 2 TB

Current position: 759 GB (37.9 %)

Estimated speed: 12,1 MB/sec

Estimated finish: 1 day, 4 hours, 36 minutes

Sync errors corrected: 0

 

I am running 5.0.4 with Simple Features 1.11 installed.

 

I am running a ASUS P5Q Deluxe Motherboard with E1500 Processor, 2x Supermicro AOC-SASLP-MV8 cards, 12 Data Disks, Parity Drive and SSD Cache

 

Sorry if this is wrong forum, but for some reason I cannot post in the 5.X Issue LIst

Link to comment

Please can you elaborate, in which way is 5.0.4 incompatible with SF? I have run 5 from early beta all though RC's with no problems which I could see from SF 1.04 and SF 1.11?

 

Looking through the forums I am aware that a replacment for SF is in the works, but it not finalised yet?

 

I have not seen many comments from Speeding Ant lately, I would be very grateful if he could comment on the current situation with regard to SF, and any updates necessary to make SF fully compatible with 5.0.4 and onwards.

Link to comment

I have just had a read of the Dynamix v2.0.2 website, which I assume will replace SF in time?

 

All the plugins which I use are included except UPS control, this was always the case too with SF, and I have had to install a seperate plugin (apcupsd) for these duties.

 

Are there any plans to create a UPS package for Dynamix? If not will apcupsd work happly along side Dynamix?

 

Whilst writting I would be very grateful for clarification on how to remove SF.

 

I assume that 1) Delete the SF folder in the config folder, 2) Delete packages folder from root directory and 3) Delete contents, which relate to SF, in the plugins folder?

Link to comment

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...