ChatNoir Posted April 25, 2022 Share Posted April 25, 2022 53 minutes ago, -Daedalus said: Since there's lots of room Depends on the minimum screen resolution considered for the UI. If it's a small/old VGA monitor attached directly to the server for occasional maintenance, there might not be as much space as shown above. Quote Link to comment
Stri Posted May 25, 2022 Share Posted May 25, 2022 (edited) On 4/23/2022 at 11:36 AM, SimonF said: This has now been added and should be in RC5. Below is on an internal test release and loopbacks are not shown now. mmh i dont see that column "capacity" in RC7 vm overview. would love to see the IP adresses of the vms there like on that screenshot.. Edited May 25, 2022 by Stri Quote Link to comment
SimonF Posted May 25, 2022 Share Posted May 25, 2022 5 minutes ago, Stri said: mmh i dont see that column "capacity" in RC7 vm overview. would love to see the IP adresses of the vms there like on that screenshot.. You neex to click on the vm name for it to show and have the guest agent installed on the vm. Can you provide a screenshot Quote Link to comment
Stri Posted May 26, 2022 Share Posted May 26, 2022 (edited) 13 hours ago, SimonF said: You neex to click on the vm name for it to show and have the guest agent installed on the vm. Can you provide a screenshot Guest Agent was not installed. Now it's working, thanks! BTW - it would be even nicer to see the IP without clicking on the VM, maybe configureable as a fixed column? Edit: OK with all that different network interfaces it would not look that nice maybe... Edited May 26, 2022 by Stri Quote Link to comment
dopeytree Posted September 30, 2022 Share Posted September 30, 2022 (edited) The general unraid console log tells you the dhcp address of any just started VM. This should be very easy to add to the UI. Edited September 30, 2022 by dopeytree Quote Link to comment
SimonF Posted September 30, 2022 Share Posted September 30, 2022 19 minutes ago, dopeytree said: The general unraid console log tells you the dhcp address of any just started VM. This should be very easy to add to the UI. The unraid log doesnt not show guest dhcp addresses. That is an internal address. you need to use guest agent to get guest IPs. Which is already there if you click on the vm name. Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.