Webui not working after changing Motherboard

[W0nderW0lf]

Hi everyone,

 

today I've built in my new motherboard, because the old one was broken.

I successfully rebuild my Server and booted back up. I get an IP and I also can SSH into my unRAID Server, but I dont know why I cant get access to the Web UI. Either on the IP Adress or the FQDN.

I tried resetting the network.cfg but that didn't help.

When I ssh into the server, I cannot find a way to check status of the running Webserver. I think in this case it's nginx? Nevertheless.. it's not working.. Any idea what can I do?

[Squid]

Can you access the WebUI via https://IP address?

[W0nderW0lf]

13 minutes ago, W0nderW0lf said:

I get an IP and I also can SSH into my unRAID Server, but I dont know why I cant get access to the Web UI. Either on the IP Adress or the FQDN.

 

[Squid]

Yes, but are you using https to try and access via IP.  If not, then from the command prompt, enter in

diagnostics

and then post the resulting file here (from the logs folder on the flash drive)

[W0nderW0lf]

Got it fixed... It seems that there seems to be a general problem with SanDisk USB Sticks. I used the SanDisk Ultra 32 GB. I copied everything from this stick to a USB 3.0 Kingston 16 GB. Now its working.

[ChatNoir]

4 minutes ago, W0nderW0lf said:

It seems that there seems to be a general problem with SanDisk USB Sticks.

Not sure about that.

Many use them without issues, me included.

 

Anyway, glad it is working for you.  

[W0nderW0lf]

Well it worked for me too before I switched the board. I have no idea why it didnt work afterwards. I googled it and it seemed that more people had issues with this type of USB.

[trurl]

USB port is more likely to cause issues than the specific stick. USB2 port recommended for boot flash.

[W0nderW0lf]

I know that fact. I always stick it in USB2, since my MB doesnt want UEFI over USB3