Hansa

Hi all, Against better judgement i updated to 6.12.10 RC.1... but for the greater good..... 🙂 All disks present with multiplyer board.. Not found any other issues. regards // Hans

newbie question, were is the limit of ports before the card needs to be multiplier? Probably 6?

MSI 970A-G43 (MS-7693) Version 3.0 No logs since i was quick to revert back to 6.12.8. but you could be correct, i should have been more observant on the serials of the disks that were missing. My bad. sorry. SATA controller: ASMedia Technology Inc. ASM1166 Serial ATA Controller (rev 02) 10 ports. Do you think this board with multipliers will be working in the future? Regards // Hans

same issue here but with my motherboard drivers. unraid see my controller and those disks but not my MB connected drives. Edit: After reverting back to 6.12.8, all disks are working again.

Ok, thanks for the answer! I just ignore it then. Any way to really ignore it so action centre dont pick it up as an error? Best regards // Hans

Strange.. This is what i get when open up Apps, CSSource installed... Click on the info and get the next pic.. And then action centre says Deprecated.... // Hans

Hi ich777..... Now when your CsSource container have been discontinued is there any other way to run CsSource? Thanks for the good work you do ! Regards // Hans

I had system temp running for a long time. After the last update it stopped working. Uninstalled it and tried to reinstall which doesen't work. Throws an error: plugin: installing: https://raw.githubusercontent.com/bergware/dynamix/master/unRAIDv6/dynamix.system.temp.plg plugin: downloading https://raw.githubusercontent.com/bergware/dynamix/master/unRAIDv6/dynamix.system.temp.plg plugin: downloading: https://raw.githubusercontent.com/bergware/dynamix/master/unRAIDv6/dynamix.system.temp.plg ... done plugin: run failed: /bin/bash retval: 4 Any ideas how to fix this? Regards Hans

Hi, When i run extended tests nothing happens, it says running but i do not get any status/messages, so i don't know if its done or just stopped. If i start another window and check, it says no tests are running. regards // Hans Edit: this shows up in the log directly after starting extended test: atd[426]: PAM unable to dlopen(/lib64/security/pam_unix.so): /lib64/libc.so.6: version `GLIBC_2.34' not found (required by /lib64/libresolv.so.2) Jul 12 04:59:08 Plexium atd[426]: PAM adding faulty module: /lib64/security/pam_unix.so Jul 12 04:59:08 Plexium atd[426]: Module is unknown

Is this valid for parity drives too? "You can even move it to a different SATA port on the MB or an add-in controller!" I have 2 that i want on a faster controller. Regards Hans