pras1011

I did what you said. It finds pwm1 and pwm 7. It wont Apply pwm7. When I Apply pmw1 and then fan detect, thats when the fan keeps running at full speed. unraid-diagnostics-20241223-1508.zip

Here you go. unraid-diagnostics-20241223-1438.zip

Nope it didnt work. I cant apply settings and when I click detect fan keeps spinning fast until I reboot.

I updated my post.

The QNAP-EC is not working now when I upgraded to 7.0.0-rc.2. I have a Qnap 473A. unraid-diagnostics-20241223-1106.zip

This not working now when I upgraded to 7.0.0-rc.2.

Thanks. The exos hdd was trying to do a rebuild and it failed with 6 errors on the dashboard. The hdd was making some strange noises!! I replaced it with another exos hdd and it worked.

Please can someone lookat my diagnotic file and tell me what this means? unraid-diagnostics-20240807-2102.zip

Seriously???

Apparently not many people are asking for wifi.

Edited the previous post.

I bought a Qnap TS-473A and it's great.

I don't want to. I just need to know how to.

Actually the Toshibas are very good and I would buy them again.

If my spinning hdd read and write speed max out at about 275MB/s when you transfer from PC to Unraid server would 5gb ethernet ports end to end be overkill?

For hdds is a controller with a 2.5gb ethernet enough? Or is 5gb better?

For hdds is a controller with a 2.5gb ethernet enough? Or is 5gb better?

I only found the UK one and it was well hidden.

Wireless unraid?

I am not using a switch. How do I turn flow control on? How do I run iperf?

Server bridging and onboard nic has been disabled already. In the future I am planning to get a NUC 13 with a intel i226 nic.

From Unraid to PC speed is about 250MB/s but from PC to Unraid its about 130MB/s. PC is a Nuc 12 with i225v nic with a 1tb nvme. Server has a TP-LINK TX401 10Gbe (Aqauntia Atlantic) nic and Toshiba 20tb MG10 drives. Both are connected to an Asus XT12 Pro mesh router 2.5gbe ports. I am transferring a single 60GB video file to and from each device to test. The server and pc nics are recognised and running at 2.5gbe. I am assuming that the Nuc is fault but what can I do to resolve this?

Reconstruct write was always on. I managed to write a lot longer than 30gb this time before the write speed crashed to 31.5MB/s. I will have to try another computer without the Intel NIC to see is this is the problem.

I got a new server and hdds and on ethernet I get 113MB/s and then after about 30GB of writing the speed drops to 31.5MB/s. I wait till its finshed and then I immediatelty write again and it starts at 31.5MB/s. I cancel it and then give it 10 seconds and then start again and it writes at 113MB/s. But sometimes it writes at 31.5. I unplug the ethernet cable on the NUC and then plug it back in and it works at 113. I am using a Intel NUC with the i225-V maybe its throttling after 30GB?

I have a qnap 473 and I have added a tp link tx401 2.5gbe card but it's not recognised in unraid. I assume I have to disable the 1gbe ethernet ports but I have checked the bios and I cant find the settings to disable them. Does anyone know how to do this?